Designers Midea did not forget about the exterior of the exterior unit of the air conditioner, which in itself is a rarity for climate technology. The outdoor unit is much more elegant than its counterparts, it has facets like a diamond, and attention to detail speaks of a high level of production and a carefully thought-out design concept.
Low-temperature (season) set – used for the operation of the air conditioner in cooling mode at low ambient temperatures (usually provided in the air conditioner as an optional feature). The kit includes the controller of the outdoor unit fan motor, compressor crankcase heater, and heater drain line.
In some series of inverter split systems, this option is implemented in hardware and software, thus if there is a need to use the air conditioner in the winter for cooling, you must install only drain the heater.
Increased heat. This unit uses the heat exchangers with tubes of a special design, the inner surface of which has trapezoidal notches “Innergrove cooper”, which provides maximum heat transfer surface area increased. Due to this heat increases by 28%, reduced power consumption, and hence increases the efficiency of the system.
Technology 180° wave inverter conversion – control voltage without the “pulse” effects (jagged sinusoid).
Compared with the current standard of 120° rectangular wave has the following advantages:
- Ability to work with a wider range of supply voltage and frequency.
- Most of the energy efficiency and energy conservation.
- More soft start, lower noise, and vibration.
- more control.
|Outdoor Model NEW||M3O-27FN1-Q|
|Indoor unit combination||Single||Double||MA-09N1D0-I
|Power supply||V,Hz,Ph||220-240V,50Hz, 1Ph|
|Energy Efficiency Class||A++|
|Energy Efficiency Class||A|
|Max. input consumption||W||3300|
|Max. input current||A||16|
|Thermal protector position||EXTERNAL|
|Outdoor fan motor||Model||ZKFN-50-8-2|
|Outdoor coil||Number of rows||2|
|Tube pitch(a)* row pitch(b)||mm||25.4×22|
|Fin type||Hydrophilic aluminium|
|Tube outside dia.and type||mm||Φ9.52,innergroove tube|
|Coil length * height * width||mm||730x660x44|
|Number of circuits||4|
|Outdoor air flow||m3/h||3500|
|Indoor sound power level||dB(A)||58|
|Outdoor sound pressure level||dB(A)||59.5|
|Outdoor sound power level||dB(A)||68|
|Refrigerant piping||Liquid side/ Gas side||mm (inch)||3 x Φ6.35/Φ9.52(1/4″/3/8″)|
|Max. length for all rooms||m||60|
|Max. length for one indoor unit||m||30|
|Max. height difference between indoor & outdoor unit||m||15|
|Max. height difference between indoor units||m||10|
|1.The above design and specifications are subject to change without prior notice for product improvement.|
|2.The values given in the table for the noise level reflect the levels in hemi-anechoic rooms.|